How to: Clear TailsEver since i created this page, everyone has been e-mailing me nonstop about the clear tails. So heres my walkthrough!1. Remove all the bulbs from the light houseing.2. Take off all of the bolts on the back end of the lights, do not loose these, they are important.3. With the houseing off of the car, get a flat head screwdriver.4. If you look around the seal of the light, u will see metal clips around the light house. With the screw driver push all of these clips in.5. Once you have all the clips in, pry the light houseing apart. *NOTE* this may be the hardest part, the silicon is really stick and strong. Make take some time and working.6. Once the light is open enough, slide out the RED lense inside of the light.7. Seal it back up with some clear silicon, push the clips back in and re-install!as for bulbs, u can either get red LEDS or paint the stock bulbs red.Also: if you run the screwdriver all around the light, you will break the seal, doing so will allow you to take the light completely apart. This will let u either take just the red lense out, or the red lense and the bottom lense.I did this a few weeks ago and it took us a good 2 1/2 hrs to take hte lights apart, taking our time and not breaking anything. Also, you MUST re-seal them or you will leak and get persperation inside the light..Table of Contents:Page 1: IndexPage 2: Exterior ModsPage 3: Interior ModsPage 4: Engine ModsPage 5: Future ModsPage 6: How To: Clear TailsPage 7: Mod PurchasesPage 8: Custom Ram Air hood,PICS!!