Close

Forgot password?

Log In | Join Now

Vehicle Owner

Member ID: Gh0sty

Location: Wilmington, Massachusetts

Last updated: Apr 01, 2008

Hits: 219

Matt’s Chevrolet Camaro:
“IROC-Z”

  • Currently 4/5 Stars.
5 guestbook comments

This is my new page for my new camaro since some jackass decided to T-Bone my 1983 Camaro and total it! But hey I look at this car as a major upgrade.

That is the 1987 Chevrolet IROC-Z Camaro I got a month or so ago. Unfortunately it has a bad carrier bearing on the passenger side and I will need to rebuild the rear end. It has a GM 10 Bolt 7.5" Posi rear which will get a nice set of 3.73:1 gears too! This just in I got the rear end looked at and it had 4.11's in there but the person who put them in before I owned the car didn't do the gear job right and the whole rear end is grenaded, wtf.To the junkyard tomorrow to get a used 10 bolt :P

It has a very nice interior. Black on black on black, just the way I like it. All leather seats that do have some tears in them but oh well. I do need to dye the carpeting on the center console and the speaker pads. The weather stripping needs to be replaced and the headliner needs to be replaced as well, with a black one :P.

I've always loved the look of the black headlights. It has a stock hood with Z28 louvers to compliment it.

It has a 5.0L 305 V8. No modifications at all, but I know around spring I will be getting a free 350 V8 from my neighbor. I will hopefully get enough money to tune that baby up.

I just hope this camaro will be better than the last and be a great ride :)

well everyone major upgrade with no pictures unfortunately, but onto everything else! I got my hooker longtube headers in from Summit that are sitting in my garage. My MSD 8.5MM wires/Cap/Rotor and blaster coil came in and I installed all of them. I got a TPI air foil and installed that. I also got some K&N air filters in too. I now need to get two new window motors, rear hatch motor/gear, drivers side mirror, new MAF, new O2 sensor. The motors can wait for now but once the MAF and o2 is in I'm going for my inspection, then if I pass ripping out most of the emissions stuff and exhaust manifolds and putting my headers on! Lets hope to a great update next time with some pictures.

Bookmark this Ride

Cars for Sale

Vehicle Owner

Member ID: Gh0sty

Location: Wilmington, Massachusetts