Vehicle Owner

Member ID: layinframe98

Location: Highland, MI

Vehicle Info

1996 Ford Mustang

Bragging Rights

  • 1/4 Mile0 sec @ -1 mph
  • 0-600sec
  • Top Speed-1mph
  • HP-1
  • Weight-1lbs

Major Upgrades

  • turbo
  • nitrous
  • bore increase
  • port and polish
  • supercharger
  • extrude honed
  • stroke increase
  • engine swap

Ratings

    • Currently 3.2/5 Stars.

Login to rate

 

Last updated: Dec 21, 2007

Hits: 98

mike’s Ford Mustang

  • Currently 3.225 /5 Stars.
2 guestbook comments

i have a 1996 stang.. orginally had a v6 but not anymore... is has a 1987 302 high output bored .010 over and ported and polished heads. Long tubed headers that go into a x-pipe and out dual 40 series flowmaster mufflers. It is a 5 speed manual trans. and has 3.55 posi rear end. It has the GT kit on it right now and cobra r rims. But i will be getting a corba kit for it. i will also be replacing all the stock gauges with auto meter phantoms. The plans for the car is to rebuild the motor and make it a 347 stroker with a supercharger or a tubrocharger. A t56 which is a 6 speed manual trans. and a ford 9 inch rear end.. And a new paint job..

layinframe98's 1996 Ford Mustang

layinframe98's 1996 Ford Mustang

layinframe98's 1996 Ford Mustang

layinframe98's 1996 Ford Mustang

Guestbook

Displaying entries 1-2 of 2

snakeonitsbelly  

Posted by: snakeonitsbelly

12/13/2007 12:02AM

I really like your conversion. I bet it was a little difficult. The Phantom gauges are really sweet though and they would deff go w/ your car. Also a set of 18's and a lowering kit will have your car lookin real mean. cause I bet it sounds good. Good luck w/ your future mods, and check my cobra out sometime! 5 stars!!!

350rsproject  

Posted by: 350rsproject

12/12/2007 10:48PM

Nice conversion 5 stars! I haven't seen too many people go carb. on those cars looks good. Hows it run? Good luck with future mods.

Show Older Comments

Post a comment

Bookmark this Ride

Vehicle Owner

Member ID: layinframe98

Location: Highland, MI