1-20-08 Just installed 10000k HID lights in my lowbeam of my projector halo headlights. These housings (since they're aftermarket) use 9006 bulbs. The install wasn't bad, had to disengage the automatic perimeter lighting cuz it kept blowing out my lowbeam fuses.
Look for these hex-bolts. Remove them and you'll be able to remove the headlamp housings. This picture is on the passenger side.
Be careful when putting the HID bulbs in, they're fragile as hell!
Anyone with the halo and LED housings knows there's a grip of wiring in them. Just keep them out of the way and don't cross them with the HID wiring.
Another shot of the clutter of wires.
I located the driver-side transformer ballast right behind the stock air intake duct. Plenty of room to make way for the bulbs wires and the extension input wire.
The passenger ballast is mounted right on the windshield washer fluid tank. If I'm stupid enough to spill the fluid on the ballast then I deserve to have a messed up ballast.
These are the connecting points for the extension and bulb wires. They can't be confused. The black and red connected to the blue and black through the single black 9006 connector is the extension wire connection. The red and blue connected individually to the red and black are the bulb wires.
And when all put together they are frickin nice! My headlight housings suck, there's a metal plate behind the projector to keep the beam from shining to high. Still looks neat though, and more blue than the picture shows.
This is them on.
This is just one. You might be able to see the halo on.
My lowbeams vs my foglights. HID vs Hyper White...No comparison.
Page 1: Intro
Page 2: Stock
Page 3: So far
Page 4: Mods list
Page 5: 1-7-08 Flowmaster installed
Page 6: 1-20-08 HID installed
Page 7: 2-8-08 Part of new system installed
Page 8: 2-9-08 DVD headunit installed
Page 9: 2-29-08 GPS, TR7, fold down installed
Page 10: 7-31-98 EDGE Programmer, K&N, LED light bar installed
Page 11: 9-04-08 3" Leveling Spacers
Page 12: 10-27-08 New sub system, custom box
