Posted by: Ace2Fine

02/02/2008 05:41PM

does that help ya?

Posted by: Ace2Fine

01/23/2008 08:49PM

pop the hood, behind each light are 2 vertical slide clips. pull each one str8 up about an inch or so, it will stop. push 'em at the motor, they come off easy. lights come foward. twist and pull each light out. try not to touch the bulbs. once out, locate the five or so small, metal clips on the peremiter fo the lens its self. may need to pull the black seal away just a lil to see them. remove these. now be very carefull when doing this step!!!! i used a 5-in-1 painters tool for this. at the bottom edge, below the yellow lens, gently pry the lens apart from the backing that held the light bulbs. once you get the whole bottom separated, wedge something between the two and slide the lenses out. get the old adhesive off the edges and re-glue, i used guerrilla glue. two ways to clear the lenses themselves. 1. wet sand them with 2000 grit sand-paper, then polish them with liquid plastic polisher. 2.pam all purpose cooking spray and a clean rag. after cleaning them of course. not a permanent fix however. clean and repeat as needed. sorry for the long post, not sure if you just wanted to clean them up or go clear.