Page 1:1995 Camaro Z28
Page 2:Wrecked 1994 Camaro Z28

NEW PICTURES ADDED6/14/08!!! Scroll to bottom of page:1.

383c.i. LT1 Stroker
Zero Decked Block / Bored .30 Over / Clearanced for 3.75inch stroke crank
2Bolt Main Caps with ARP Studs
4340 Forged Eagle 3.75inch Stroke Crank
4340 Forged Eagle 6.0inch H-Beam Rods
Forged SRP Aluminum -3cc Pistons
Stock Oil Pan Clearanced by Myself / Stock Oil Pump with High Pressure Spring
Advanced Induction-Trickflow 210cc heads/Custom Cam
Jeff Creech PCM 'base tune'
Dyno Tuned by 'Steve' at Backstreet Performance in Medina, Ohio.
42lb Lucas Fuel Injectors
Walbro 255lph Fuel Pump
Aeromotive Fuel Pressure Regulator
BBK 58MM Throttlebody
Lightly ported stock intake by me
Granetelli Mass Air Sensor
K&N Fuel Injection Performance Kit (cold air intake)
Vortech Air Inlet Elbow
High performance hydralick roller valvetrain kit from Advanced Induction (Valvetrain details coming soon)
Nitrous Express Wet Shot kit with bottle heater & Purge kit set to 150shot.

MSD 6AL Ignition
MSD Blaster Coil
MSD Optispark cap & Rotor
1LE Air Conditioner Delete Pulley
Lontube Pacesetter Headers
2.5inch Dual Exhaust with X-pipe
Dual Flowmaster delta force race mufflers with dumps before axle
AAM 4:10gears/Eaton Posi-Trac
Ten Bolt Rear End / SPEC Stage3 clutch kit
UMI Rear Control Arms / UMI Panhard Bar
Fidanza alumunim rebuildable flywheel/ 17inch Corvette ZR1 Wheels/ Stock brakes / 1LE Front Swaybar
Removed EGR / Removed Air Pump / Removed Air Conditioner / No Emissions of any kind
Removed Evaporator Core / Custom Sheet Metal 'heater box'

Went for the 'stock appearing' look under the hood--can you tell?

My painted 10bolt Jegs bearing support cover, 4:10gears and eaton posi unit. Picture was taken before the UMI Control Arms and Panhard Bar went on.
Painted most of the underbody of the car Gloss Black.

~~~NEW PICTURES 6/14/08~~~