June 1, 2009
Well its about time to finally start putting the engine together. Sent out the OEM flywheel to get shaved. Got it back and starting putting things together.
Exedy OEM replacement Clutch works for me. I'm not planning on making crazy whp, so this is just fine.
For those of you wondering how much a stock flywheel weighs, look below.
June 3, 2009
Well couldn't put the tranny on till today. Had to order a few parts from honda. So here it goes.
Bought 2 seals, along with a dowel pin that was missing, the breather cap, and the 2 washers which I'll replace when I fill the tranny back up with Honda MTF.
New Release bearing install..................................Tranny ready to go on
Tranny installed. ^Here you can see that I used the 3rd gen hose for the left side.
I also received my Battery Relocation Battery Tray today, powder coated to match the rest of the stuff in Sun Gold color.
June 5, 2009
I decided to tackle the coil wiring today. its was pretty simple. Made the wires longer. Hooked up a connector, heatshrinked, covered, taped and done.
Went to Radio Shack and got these connectors, work pretty good.
Spliced in extended wires...................Heat shrinked over top...........Plug splice in & soldered
Wires all wrapped up and taped up together.........Here's the connector where the old coil was
Another shiny thing to come today was the powder coated Valve Cover, yup same color: Sun Gold
^My Model..........and Daddy's Little helper.
Unfortunately you won't see this valve cover on for a while, as it would be one of the last things to go on, for obvious reasons.
PG.1 The Beginning
PG.2 H22 swap parts
PG.4 Wiring & New Suspension
PG.5 Brake Lines, Battery, Radiator & Review
PG.6 Dash Removal, Some Wiring & Shift Linkage
PG.7 Stripping, Test Fit H22 Mounts, M2F4 Tranny & Power Steering Hose
PG.8 Rear Adj Endlinks & Powder Coated Parts (Test Fit)
PG.9 Battery Relocation Tray, Battery and Engine test fit, Fuel Line & Goodies
PG.10 You are HERE
PG.11 ESP Traction Bar & Engine Re-Install
PG. 12 K-Sport Coilover Suspension install & Raxle axles
PG.13 Forbidden Motorsports Short Shifter & new exhaust parts
PG.14 JVT Radiator & Install, Password JDM Fender Washers, Coil Relocation, & Interior parts
PG.15 Fuel Filter, SS Brake Lines, Shifter Assembly Install, Engine Bay
PG.16 Intake mock up, Lude washed, & New Wheels
PG.17 Slammed 3GP
PG.18 Raised to ~2" Drop and HKB HUB/NRG Quik Release/NARDI Steering wheel
June 1, 2009Well its about time to finally start putting the engine together. Sent out the OEM flywheel to get shaved. Got it back and starting putting things together.