This page is going to be devoted to the interior build and the wiring harness.
Under the dash everything is put back in its place-a little dusty in pic.
UPDATE: 12/2/07
The new seats came in, they are the generic Summit racing buckets, but they look great and feel amazing.
UPDATE: 01/04/07
The 8pt roll cage has come in, as well as the clutch, throw out bearing etc...
UPDATE: 02/17/08
Started to put in the wiring harness, only a few issues needing attention before wiring continues
Since the battery was relocated to the trunk, a distribution block was installed to make routing wires easier
UPDATE: 03/05/08
Everything is now painted up, time to put new stuff back into the car! The wiring harness (pg.3) is going in, almost done except wiring the dash. The entire bottom of the car is imeroned gloss black (pics when i feel like crawling on the ground), new rear suspension and Dana 60 comming next month.
The roll cage is going in, its only going to be a 4pt cage for now. (its a "street car" after all, gotta be passanger friendly)
UPDATE: 03/23/08
The carpet is put in, new door panels were made, dash was perminantly installed. Wiring is almost completely done, i dont know whats going to spark or not...
UPDATE: 03/28/08
Put the headliner up, and interior panels on I made the upholstery for the doors,rear panels, and the rear sill area where the speakers go. The battery box is in and wired for the trunk, waiting still to test wiring; only 6 loose unwired connections still!
I dont know if the rear seat is the original (dont think it is) but if it is, i found the whats left of the original build sheet (above) inside the seat.
UPDATE: 05/15/08
The seatbelts and mechanical drive for the speedometercame in, installed both, all thats left is to install the engine/trans
UPDATE: 05/21/08 Just a few pictures of the wiring before the engine covers it
Linelock :)
