NEW PROJECTOR HEADLIGHTS INSTALLED
THE PROJECTOR HEADLIGHT TO HID INSTALL
ORDER A H3 HID KIT AND PICK YOUR COLOR TEMP, I USE 12000K HID LIGHTS
STEP 1: Remove headlight out of car and twist off the cap that is over the lo beam from behind the headlamp.
STEP 2: Use a screw driver to remove the existing H3 light bulb
STEP 3: Unhook the white cable from the green cable, this will be the red wire of the new light bulb.
STEP 4: Unscrew the screw that is holding the black wire in place and this black wire will connect to the black wire of the new bulb.
Here are the connections above hook up the green wire to the red wire of the new bulb and the black wire will hook up to black wire of the bulb.
Here are pics of the wires connected
Take the foam off the bulb and put the bulb inside where the existing bulb was
screw everything like it was when you removed everything.
Here is a pic of everything hooked up to the headlamp from the above pic.
Find a place to close to the headlamps to put the ballasts (The Boxes) That connect the wires from the light to the boxes where you removed the headlamps in the car. You can drill holes to secure the ballasts properly, But my trick is using two zip ties to keep the ballasts connected to my car. Here is an example of the ballasts screwed to the bottom when I did the fog light.
Then just put the headlamp back in its original location and your all done.
Above is the HID compared to the Halogen Bulbs from my car
12000K HID ANGEL EYES AND FOGS ON
JUST CHANGED THE AMBER BULBS TO CLEAR BULBS THAT LIGHT UP AMBER WHEN ON
