PAGE 1: Current State
PAGE 2: Frame Up Build
PAGE 3: Some Bad Ass Trucks
PAGE 4: Tailgate animation (High Band)
PAGE 5: Tailgate animation (Low Band)
PAGE 6: Mods and How-to's
PAGE 7: Carputer Install
PAGE 8: My El Camino
PAGE 9: Jason's G-35, "The G-SPOT" and his "OLD" truck
High Band Animation
Enlarge the picture and be patient. It takes about 5 seconds on my computer with DSL. If it fails to load try the low band page.
I installed an actuator that lifts and lowers the gate. No handle -inside or out. I engineered the entire unit myself. At the time there were no kits on the market to do this. But since then I have seen one but I don't like it much because you have to mount the actuator to the tailgate where it will be in the way. Mine is against the bed side and uses a cable that mounts to the edge near the stock cable. The total lift time is about 4 secs, and it is also hooked to my alarm so I can drop the gate as I approach it. The unit is all contained in a small box on the inside of the bed-hardly noticeable. I finished it today and it works perfectly.
