How to: Install O-nex HID kit on your fog lights for IS300

1 - Remove these two plugs under your fender.
Note: If working on driver side, turn wheel to the right. Reverse direction when working on passenger side.

2 - Carefully open your fender to get to your fog lights.

3 - Remove H3 bulb, disconnect from ground and power.

4 - Disconnect H3 bulb from factory harness.

5 - Optional: You can drill a tiny hole for the wire to come through. If you skip this option, then your wires will be exposed.
Note: Remember to remove the rubber ring before cutting or drilling. = )

6 - Find a place inside the fender to mount the ballasts and make sure they are securely mounted.

7 - Connect ground and power to factory harness.
Note: Red = Power, Black = Ground

8 - Connect your kit together, match A to A, B to B and C to C. It's so easy, a caveman can do it.

9 - It should look like this when you are done.

O-nex HID Conversion Kit (made in Japan), visit www.xenonspecs.com.

To purchase O-nex HID kit, please contact (626) 616-0497
or email: sales@xenonspecs.com and tell'em VYPER sent you! = )

===============================================================

HID fog light conversion mod:

Thanks again for visiting and drive safely!~ = )