DIY Side Markers
By Club Lexus's Debonair
Tools Needed:
Philips Screwdriver
10mm Mini Ratchet
Remove the two Philips screw on the inner edges of the fog lamp housing.
Pull out on the inner edge of the fog lamp.
Now pull toward the center of the vehicle at a 45 degree angle. The fog lamp housing will now come out of the bumper.
Unplug the fog lamp housing and place it to the side.
Now the "hard" part. Maneuver you hand into the front bumper toward the side marker. With the ratchet loosen the two nuts. Once loose the nuts can be spun off by hand.
Once the two nuts have been removed the side marker will fall or pop out of the bumper.
Remove the light bulb socket from the side marker. Now is a good time to clean the bumper where the side marker sits. This is also a good time to replace or upgrade the bulb.
Remove the square head bolt from the old Side marker and install it into the new side marker,
Install the new side marker into the bumper following the same procedure in reverse.
