Interior - Custom gauge panel
After collecting a full set of Autometer carbon fiber gauges, I was ready to start modifying the original plastic piece. I used 5" speedo and tach, so I had to enlarge those holes using a 4-1/2" hole saw. The other five gauges are 2-1/16" and I cut holes in the panel to make an oval. Then, I used 1/8" abs plastic and a 2" hole saw to make the insert. Next, I glued it in and here's the result:
Next, came the wiring and I used 8 row terminal strips to organize sets of wires easily (power, ground, light).
Finally, the only thing left was to run the power/ground from the factory wiring harness and the sending unit wires to the gauges. I used about 2ft. of wire for each, which made connecting everything up before mounting the panel a breeze.
