***IF you even MILDLY enjoyed this page, how about voting 5/5 for it? Its not like your doing anything else more important right now, and maybe then i'll be inspired to upload more gravel pit vids. This site is a huge work in progress, check back often if you care!***
this place is offically way too restrictive,
please check out my real page at
http://www.allykatauto.com/tech.html
PAGE 1:SUNBIRD
PAGE 2:TECH / VARIOUS PROJECTS
PAGE 3:ABANDONED WRECKS / BARN FINDS
PAGE 4:GRANDPAS' TIP CORNER
PAGE 5:THE VIDS!
____________________________________________________________________
TECH PAGE:
1) FIXIN' A SHITTY 74 MERCEDES FLOOR PAN, LOW BUDGET!
2) FIXIN' A SHITTY 80 VETTE FLOOR PAN, extra low BUDGET!
3) SMOOTHIN' OUT A 73-87 CHEVY TRUCK FENDER FOR FREE.
4) MAKIN' A SUICIDE RIDE, A SNOWBIKE TO BUMPERDRAG WITH!
All this black engineering requires some serious fuel! This is step 1 in every project.
_________________________________________________________________
PART 1,
FIXIN' A SHITTY 74 MERCEDES FLOOR PAN, LOW BUDGET!
Not the hottest lump, but the old man likes it.
Had it since new, its solid 'cept for the floors.
wats a poor ole _______ supposed to do?
old shite 1/2 cut out...
donor metal from a old cav hood that was sitting around.
There was nothing left but a picture frame in the end...
The first piece + test fit...
All done and kitty-haired for extra goodness.
The old man wanted me to put the old original, most disgusting rug i have ever seen in my life back in. I refused to and instead put in this blue rug out of the cav. It is the only good part in the whole car. It makes a huge difference. It is not perfect, but is 1000x better than what was in it. And it was free too!
_________________________________________________________________
PART 2,
FIXIN' A SHITTY 80 VETTE FLOOR PAN, extra low BUDGET!
Some people think Vettes don't rust, what would you do if you found this in your "new" Vette?
the car...
...the floor
...the cut out, and all the tools you need, minus welder!
....the test fit, getting there!
done and undercoated. That wasn't so bad now, was it? Better than giving up on the wreck.
_________________________________________________________________
PART 3,
SMOOTHIN' OUT A 73-87 CHEVY TRUCK FENDER FOR FREE.
It was -48c out when we did this swap,the coldest it was in 100 years here, I would LOVE to see one of those crybaby rustfree "WEST COAST" mechanics work in below 0 temps. yea right.
"you mean water acually gets hard?"
So if something dosen't quite meet your high standards on this one, it's cause hell froze over this weekend.
This is the start....
You need a peice of sheetmetal and some snips...
....finished and installed.
...grimy assed engine.
...clean assed engine.
purple loom , no time to cheap out now!
purple loom in action.
engine going back in.
This is the beast...
Here it goes...
PART 4,
MAKIN' A SUICIDE RIDE, A SNOWBIKE TO BUMPERDRAG WITH!
First ya need a dilapated bike to start with, I'm sure you can find one...
Then it gets stripped down to nothing...
And ready for paint...
base coat
the center get stripped down to nothing...
wooden test skis, getting close to the end.
_________________________________________________________________
