Engine and Mods Page:
AEM Cold air intake that comes down to the hole in the bodykit making it fully functional!
This is where the cold air intake comes out of the front bumper, if you look closely you can see the cone in there
Catback system arrived in the mail! This is still in the bubble wrap before being installed. Also in the picture is the Y-pipe from the cats to the exhaust system. The whole system is 3-inch!
The Megan Racing Y-pipe
UGLY stock exhaust on the car!
Compare the stock exhaust system VS the aftermarket system!
Exhaust system and y-pipe installed!
The rear bumper off the car
The tires and rear bumper off the car for installing the springs and catback exhaust system!
Stock springs on the front shocks
The rear spring on the car, nice and green!
After completion, still in the lifting bay at the base where we did the work.
Tein rear lower camber arms to adjust negative camber
Megan Racing non resonated test pipes for that extra growl and exhaust note sound
Stillen Engine torque damper, helps the engine not roll so much and keep the extra torque to the ground
Custom oil pan since the stock one was broken and leaking out which had to be replaced in order to drive the car
The car did not come with an HID setup so I had to buy one online from Japan, here it is.
What came in the box. I ordered the H7 8000K color temperature kit which would look pretty bright blue at night and match well on a blue car.
This is where I mounted one of the Ballasts for the HID kit
side view of the HID turned on at night
front view of them turned on as well
The side pillars were all scuffed and scratched from wear and tear as you can see
So I bought Varis carbon fiber pillar covers to cover them up and here they are just arrived from Japan
This is the outlook after I installed them on the car, what do you think?
LED Tails I ordered
New custom bubble LED taillights just arrived!
Installed and turned on
Back end shot of them installed but turned off
Pics of the tails on at night
The New JSP reverse vented CF hood before being installed
JSP Reverse scoop from the back when installed
JSP hood went bad with fading so I bought a Seibon TS carbon fiber vented hood, with red SPARCO hood pins
"SEIBON" emblem inside of the hood
Inside view of the hood to show the vents
On a dirty car after the rain, the TS hood installed
you can see the SPARCO red hood pics as well, came on the hood when I bought it
New Carbon Fiber Veilside V.2 rear lip spoiler
side shot of the wing
Closeup of the wing installed and my Agency Antenna
Back shot of the wing installed
Agency Power Billet Aluminum black S2000 "shorty" antenna (much better than the rubber S2000 antenna, and also it is much shorter!
After the accident we worked on remolding the bodykit to the car
