We're havin FUN now!

I've deciced to put the computor out in the kick panel area
area. I'm building a steel box that will protrude out
to the area where the wires are in the second photo
and house the ecu. It will be assessible from behind
the interior kick panel.
All the wires were hooked up that the motor needed to run
but the harness needed to be stripped and the length of most
of them needed to be altered to fit their new home.




Progress has been slow but it's coming together nicely.

First pic is looking up into kick panel area with end of
heater showing and second is with panel installed.
The next pic is taken from under the dash with the glove box
out and shows mounting of fuel pump inertia switch
and power relay as well as the barimetric pressure sensor.
Not in the pic is the test leads which pull out and are
accessed here. This was unused space between the glove box and end of dash.