Page1:exterior
Page2:modifications/future plans
Page3:engine/other
Page4:interior
Page5:audio
Page6:the Paint job.
Page7:turbo build.
Page8:Hid conversion
Modifications:
Engine:
warm air intake
magnaflow exhaust(cat removed)
short shifter(a.s.a.p)
apc air breather
ractive intake filter
moto-master battery
new 2.8 engine
white wire covering
blue wire covering
taylor 8mm plug wires(blue)
new clutch(may/23/07)
new pressure plate(may/23/07)
polished intake manifold
polished valve cover(soon)
painted intake manifold
painted valve cover(soon)
mr.gasket wire separators
high pressure rad cap
chip(not installed)(made by scott0999)
ractive hose sleeving kit(not installed)
Exterior:
cool-blue headlight bulbs
8000k hid low-beam conversion(on the way)
6000k hid high-beam conversion(on the way)
chrome clear corners
custom badgless grill
5% tint
phase 2 spoiler(from a 94)
shaved badges and mouldings
window decals
rally foglights(not installed)
body work(done summer of'07)
new polar white paint(10/22/07)
hood painted gloss black(10/22/07)
painted callipers blue
color matched mirrors
color matched bumpers and skirts
shaved antenna(cut down)
custom taillights(made by alpel)(3/01/07)
Interior:
blue seat belt covers
alfa otto glow gauges
apc pedals
apc shift knob
apc shift boot
aluminum look floor-mats(soon)
fold down backseat(from a 89)
buckets with tilt(from a 94)
trunk carpet(from a 92)
blue neons in back-seat
blue neons under dash
blue neons under the seats
painted interior pieces
white panel vinyl in back
custom switch panel
custom upholstered seats
custom rear fiberglass deck panel
power import s-wheel
momo hub adaptor(on the way,yo)
Handling:
canuck lowering springs
new tire rod end(old)
new c/v joints(jan 5 07)
new axles(jan 5th 07)
17" dai rims(1 rim brand new)
40 series antire rubber
jasper brake pads(old)
monroe shocks(old)
phase-1 strut bar
painted/polished strut bar white
Audio:
stinger wirring kit
concept dash speakers
400watt kenwood 6x9s
2-12inch 1200watt kenwood subs
clarion deck
280watt kenwood tweeters
tweeters mounted on side panels in front
2-kenwood crossovers
400watt kenwood amp
1800watt kenwood amp
scosche 500watt capacitor
mb quart sub box(non-ported)-not installed
power distribution block(with fuse)
ground distribution block
remote turn-on distribution block
Future:
Idle relearn(cause of the chip)
new headliner(possibly in vinyl)
new carpet
get backseat upholstered
possibly get custom door panels
get the tranny rebuilt/aftermarket flywheel
upgrade the gears in the tranny
upgrade the axles/differentals
rebuild the alternator
bored headers and intake manifold
full fuel system for my car(n/a)
big bore 62mm throttle body
underdrive pully
lightweight alternator pully
rear strut brace(n/a)
strut bar covers
turbonator vortex generator(if it's the real deal i will buy 1)
optima yellow top battery
underglow
custom strut brace(made by myself)
*some things are undecided*
Misc:
cobra radar detector
viper car alarm
car-tarp for winter/summer
car battery warmer(for winter)
...
Fluids:
quaker state 10w30
k&n oil filter
prestone antifreeze/coolant
motomaster washer
motomaster tranny
bardahl power steering
valvoline DOT 5 brake
....
Replacements:
used engine mount
p/s window crank
upper gaskets and seals
used washer lid
positive terminal(side)
used 1990 z24 rim&tire
all new brake bulbs
fuel pump relay
Comments:
Well level 3 is completed now it will soon be time to play level 4.Look in my futurre mods list to get an idea of what i have in store for level 4.
