*update*

It's been awhile since I was last on here so here are a few updates..

My wheels have been painted ( by myself, long story about the "proffesional painter")
I have gotten my shifter rebuild kit from marlin crawler
I have ordered a semi-metalic clutch from marlin crawler (1,200ft lb clamping vs. the stock 900ft lb)
Have purchased 4 procomp es3000 shocks (good for 2" of lift)
along with the shocks I have a 2" procomp rear add-a-leaf
I almost forgot!
I also got a set of aisin manual hubs.. for free!!!
All they took was 3 hours of cleaning, a coat of paint, bolts and gaskets and they where ready to install.

Here is a picture of the hubs after I finished painting them (before the camera went belly up)

I will be ordering my balljoint spacers to complete my suspension lift (for now ;) )
I have made time in may to get new cams from sea2sky tuning put in.
I will be then buying the 3" body lift after cams are done ( so I have time to get more money together :D )

oh and final thing.. my camera took a shit on me and will not upload.. so everone will have to sit tight untill I get it worked out..

*update*
Well finally my camera works again so here are some pictures.

The rims (other two are just out of the shot)

The procomp shocks (not going to run them with boots)

The Procomp Add-a-leaf(s)

Updated July 10th

I purchased a roll bar for the truck (more or less just a light bar)
Talked the guy down to 30 bucks as it is tweaked a little.
The point where the tubes connect is falling apart so hopfally my buddie can weld it all up for me and add 2 more light tabs so I can mount 4 off road lights :)