The Specs
---------------------------------------
-1988 Bronco II
-2.9 v-6
-FM145 5-speed manual transmission
-Borg-Warner 1350 manual transfer case
-Dana 28 front axle geared to 3.45:1
-Ford 7.5 rear axle geared to 3.45:1
-Factory manual locking hubs
Here's what I'm starting with. It's a 1988 Bronco II bone stock with 150,000 miles. I picked it up for $300 after the previous owner had abused it and rolled it. $200 later with a new locking hub, wheel bearings and rotor it was on the road again. Because this thing gets great milage (about 18-20 mpg)I've been driving it daily but it's real future is on the trails.
==============================================================================
My goal is to end up with something like this: This is RenegadeRon's '84 Bronco II, it is one sweet rig! His site can be found here: RENEGADERON
==============================================================================
This is where I spend too much time!---> BRONCOII.ORG
The upgrades-in-wainting
--------------------------------------
-Dana 35 front axle geared to 4.10:1
-Ford 8.8 rear axle geared to 4.10:1
-Ford Explorer front springs
-Ford Explorer rear springs
-Custom fabricated front and rear bumpers: materials pending
-Custom fabricated spare tire/fuel can/ hi-lift jack carrier:
materials pending
-Ford Explorer bucket seats and center console
