Well I started a new page to show some of my minor projects that I have been doing. Plus my first page was getting a little full from all these extra projects. I started a new project but not by choice, I blew the posi in my rear axle and so I posted some pics of the carnage for you. Also some pics of the newly finished carb setup.
Some pics of the power window motors installed...out with the old and in with the new.
Got the holes for the high rise spoiler cut and the old holes welded up all we got left is some bondo.
Hopefully I get this on soon.
Finally the last rim, taped out and painted.
Before and After
Started repolishing my rims, stripped off all the clear coat and painted the gray area black, make the rim look much nicer.
Got a new Alpine CD play for Christmas, also play from Ipod and USB. Also got a 32GB USB thumb drive so I can put all my music on it.
My dad spraying the paint. The final product.
My box that I recovered in tan. Looks good for the first time covering something. Also my Rockford Fosgate fuse from my wiring kit.
My Trunk motor also took a dump out of no where.
There was a low spot on the one side so we took it off the try and fix it.
My dad spraying the hood also before and after pics.
O boy more sanding :(
Well I have finally dug into a project that I have been procrastinating for a while. I notice while installing the motor one of the Heater core fittings was broken off. Since my car is in the warm end of the shop I figured I'd dig into it. The Haynes manuel I bought helped a lot. Also the Water pump I put one leaked so I got a new one of them.
Pictures of the hole, the patch panel, and hole patched.
Rear End Swap going to 3:73 posi instead of 3:42 open rear.
Started to Nightshade my lights. Where did the Parking Lights go?
Pioneer DEH-P4600MP Deck, Alpine Type S speakers.
My infinity speakers in the font.
Also painted this plate black and then filed down the Letters to the Aluminum. Looks Pretty good.
Well as you can see in some of the other pictures the paint of my front bumper is pretty trashed. I decided while it was in the shop that I would take it apart and repaint it.
Took like 3 days but its finally all sanded, had to do it by hand.
Also started sanding the bumper
And about 4 Days Later
My new LeCarra Billet steering wheel much better than the original.
Finally put on
_
Page 1- Exterior Pictures
Page 2- Motor Pictures
Page 3- Engine and Trans Install
Page 4- Cars around my house
Page 5- Projects---You are here
