The motor with the carb setup has run geat so far but recenlty I over reved it and bent the exhuast vavle in number two cylinder so I ripped it apart to fix it. I decided to buy new valve springs and valve guide seals(the old ones leaked) and replace them while I had it torn apart. I posted som pics of the project below.
New Valve and new Seals
New Springs
The heads out and I think I found the problem.
Ripping It apart once again, I think this is the third time.
Going back together....holy carb studs!!!
While I'm there I decied to put a cam in it.
Ripped Apart
What I started with
Air Intake Sensor Old--> New
All buttoned up just need to get some air filters for the stock one. Put that one on just for fun.
Almost ready to Fire
Rerouting all kind of wires.
All Bolted in and started putting it together.
Motor on the lift and in the car.
Some cool pictures of the motor in front of the car.
Car in the garage a waiting the motor.
Engine Compartment Before and after paint.
The Trans finally is in, doesn't look like it but it is. The Hurst shifter and the console are in too. All ready for the motor and clutch.
Got the car out of the garage to clean the engine compartment. Used the pressure washer looks better.
Page 1- Exterior Pictures
Page 2- Motor Pictures
Page 3- Engine and Trans Install---You are here
Page 4- Cars around my house
Page 5- Projects
