Well it's officaly over the talon has been stripped and parted to pay for my new car:( It's SUCKS but thats how it goes.)
This car was a blast wail I had it and would say to anyone still building on a DSM to stay with it!
So here's to my 1990 Talon TSi! You'll live forever in cyberspace and in my heart!
Motor
-JDM 4g63 2.0 block
-JDM 9.5 to 1 pistons
-JDM 252 262 cams
-Cast iron crank
-JDM cyclone intake manifold
-JDM ignition coils
-1G tsi 65mm throttle body
-2G Greddy intake
-2G MAF
-XS big fmic 28"x 18"x 3"
-custom 2.5' ic piping
-HKS ssqv
-Koyo big aluminum radiator
-Custom slim line fans
-Samco sport blue silicone hoses
-Vibrant performance blue silicone vacuum lines
-Vudoo racing vacuum line elimination
-Prourathain motor mounts
-JDM AWD trans
-Spec stage 3 six puc clutch with stage 4 2600lb pressure plate
-A/C delete
-Cruze control delete
-Vaccuum relay delete
-Optima red top
Turbo
-Greddy 18G turbo with full custom rebuild
-Custom ported
-Ceramic coated
-Turbochargers.com custom compressor wheel
-Mock V motorsports 7cm steel monster turbine housing
Exhaust
-Punishment racing custom 3" O2/ down pipe with WG block off
-punishment racing custom turbo manifold
-Tial 38mm waste gate
-Custom 3" stainless steel turbo back CAT delete with all V-band clamps
-OBX-R N1 flow through muffler
Electronics
-Custom E-Prom ECU
-Apex-i S-AFC II
-Apex-i AVC-R
-Greddy turbo timer
-Faze gauges boost, a/f, water temp, oil press, volt, and 5" tack
Fuel
-RC 550cc injectors
-Walbro 255lph fuel pump
-Aeromotive regulator
-Summitt racing SS 6AN fuel lines/fittings
Interior
-Fully gutted
-F1-spec full race seats
-OBX-R 5 point race harnesses
-Custom HVAC gauge mount
-Custom console switch panel with push button start
-Custom sort trow shifter
-Ichibahn carbon shift knob
Exterior
-Custom molded drift body kit
-Custom drift style front bumper quick release clips
-VIS OEM Carbon hood
-SS slide lock hood pins
-Tork Matrix 18" staggered wheels
-Power slot cross drilled slotted rotors
-B&R 2.8" drop springs
-Front and rear strut tower braces
-anti social flat black paint...
Here's my car with the old wheels
JDM 4G63 Cyclone
Faze Gauges Apex-i S-AFC and AVC-R 
OBX-R 5 point harness F1-spec race seats
New Wheels!!!!
Staggered 18x8 front 18x9 back
New Greddy 18G rebuilt and ready to go!!!!!!!!!!
If you like this build come check out my new car 2004 SRT-4!
