Vehicle Owner

Member ID: eclipseURcar

Location: NY, NY

log in to make me an offer!

Vehicle Info

1989 Mazda RX-7

Bragging Rights

  • 1/4 Mile0 sec @ -1 mph
  • 0-600sec
  • Top Speed-1mph
  • HP-1
  • Weight-1lbs

Major Upgrades

  • turbo
  • nitrous
  • bore increase
  • port and polish
  • supercharger
  • extrude honed
  • stroke increase
  • engine swap

Modifications

Performance Parts

  • Custom Intake 
  • JET Perf. Chip 
  • A'PEX Exhaust 
  • NGK Ignition 
  • Hedman Header 
  • Racing Beat Strut Bars 
  • Brembo Brakes 
  • Eibach Springs 
  • KYB Shocks 
  • Custom Transmission 

Interior

Exterior Styling

  • Bomex Body Kit 
  • Falken Tires 
  • Advan Wheels 

Ratings

    • Currently 2.7/5 Stars.
    • Currently 2.8/5 Stars.
    • Currently 2.8/5 Stars.
    • Currently 2.7/5 Stars.
    • Currently 2.8/5 Stars.
    • Currently 2.7/5 Stars.

Login to rate

 

Last updated: Jul 11, 2007

Hits: 664

Jason’s Mazda RX-7
“Swapped Dropped and on Top”

  • Currently 2.7333333333333 /5 Stars.
6 guestbook comments

14th RX7 lol

eclipseURcar's 1989 Mazda RX-7


Car was bought 12/11/06 this a start to a long road ahead as you can see previous owner started doing stupid things to this car stock grill cross-over's cut out and replaced with chicken wire also the flash to pass lenses removed Chicken wired also! Then the OEM GTU stick on's wouldn't come off all the way and he put APC stickers over them why? Door handles,and stock wing painted black to match window trim again why?
Overall the car is in very good shape interior has been very well taken care of there is no body damage and no rust this car is going to be striped down bare and completely re-painted undecided on the color. The interior is black with red pin striping on the seats I will be replacing the seats with a racing pair.

Plans are to re-vamp this once majestic sports car from this Rice stage of its life that it will never see again by pairing it with a CorkSports front end, Bomex Rear bumper, and side skirts, Re Amemia side mirrors, Advan rims + much more!
Change of plans got a killer deal on GP-Sports full kit!
eclipseURcar's 1989 Mazda RX-7

Off to the garage! Following in the Type-R lol eclipseURcar's 1989 Mazda RX-7

Time to get it started swaping in a Supercharged-LT1 this is the kit im using

eclipseURcar's 1989 Mazda RX-7

@ 5psi it makes 425HP on stock motor. The LT1 im using is out of a corvette it has 19k(orig)
miles. For $2,600 I bought the LT1 with full harness,AC and ECU the motor already has head work done and is flowmatched to the block.

eclipseURcar's 1989 Mazda RX-7 Here is the stock NA 6-port 13B its so clean shame it blew the rear apex seals

eclipseURcar's 1989 Mazda RX-7 Here is a pretty good shot of the interior Gauge surround was painted other then that the interior is mint just need to replace the pass door panel with a GTU cloth panel it has a black leather one in place now.

eclipseURcar's 1989 Mazda RX-7 My motor that hasn't seen light in 12yrs only 19k miles

eclipseURcar's 1989 Mazda RX-7 My 1993 M29 Viper spec trans sitting in the back of my Type-R after my new friend Adam drove 5hours to drop it off to me it only has 13K miles on it.

eclipseURcar's 1989 Mazda RX-7 why people think that the Rx7 becomes very heavy and un effective in corners after the LT1-T56 is pure nonsense. After the full swap the Rx7 become around 28lbs heavier than that of a stock FC with a single turbo set up.

eclipseURcar's 1989 Mazda RX-7 Just after we put her in my garage to start the swap you can still see the towrope hanging there lol starts and runs moment you go to drive it it fluds and stalls out you can start it again if it will let you

eclipseURcar's 1989 Mazda RX-7 Tried my new set of RX8 rims on look pretty trick cool cause there 18s from the factory but on the Rx8 they fit awsome my Rx7 just need a small spacer up front! fills the 7s wheel wells perfect.

eclipseURcar's 1989 Mazda RX-7 5/1/07 got the 13B out today FOR SALE! $1200 everyhing including trans, ECU, etc. Racex7@aol.com

eclipseURcar's 1989 Mazda RX-7 Both my motors in front of the FC
(Choose Your Weapon)

eclipseURcar's 1989 Mazda RX-7 Motor and trans is in still needs to be level and trans member installed but thats were im at now thanks to steve helping with the wired harness without him i most likley would have cut it lol. big mess

Guestbook Ratings

Displaying entries 1-5 of 6

player_862  

Posted by: player_862

07/11/2007 10:03PM

Whats Up Nice Ride I Like IT 5 Star keep Up The Good Work And When You Get A Chance Come Take A Look At My Ride And If You Want You Can Join My Group Here Is the Link

http://groups.cardomain.com/groups/10477/pages/10593

Later

jynxdlife  

Posted by: jynxdlife

04/01/2007 02:23PM

looks like you got some plans going. looks good . thought but at one time doing a v8 swap with a 5.0 but decided to stay rotor. anyway when you get a chance come check out my 87.

MYIROCDAYTONA  

Posted by: MYIROCDAYTONA

03/30/2007 06:33AM

Hey, Nice car, looks clean! I like that T/A Challenger poster in the background too! -Justin

LS1T56FC  

Posted by: LS1T56FC

03/25/2007 08:02AM

awww man come on you forgot to add my fat ass into the vehicle weight, I'm a 220 pound fatty and definitely not the best driver. I'm stoked to get the car to the strip again with the new CAI setup and some 295's out back with hopefully a much better alignment using less negative camber. so whens your rx7 gonna be up and running strong????!

LS1T56FC  

Posted by: LS1T56FC

02/14/2007 06:59AM

I sold my 5zigens a month ago, sorry man. you can pick up some 17x10 +35 / 17x9 +25 pretty cheap and run a 275/245 tire setup under stock bodywork, no problemmo.

Show Older Comments

Post a comment

Bookmark this Ride

Vehicle Owner

Member ID: eclipseURcar

Location: NY, NY