Posted by: justabird

09/25/2007 07:29PM

Hey stranger!!! Stoppin by to say Hi N see how far you've got with your project??? Hitcha 5 stars....Drop a post on whatsup! Always keep em smokin....Then let er drift!!!! Steve

Posted by: Regina5683

09/03/2007 06:26AM

Hi, I wanted to get some information about the Sunbird you have. Please email me at regina5683@hotmail.com.

Thanks

Posted by: cchriss92

07/03/2007 12:58PM

Nice, its got a lot of potential, just wondering what's up with the wing on the back?

Posted by: justabird

04/08/2007 09:50AM

I built a 455, had it installed and hooked up to drivetrain and even started the motor before realizing there was no room to install the radiator without streachin the front end. A 350 is bolt in but U can't use the Bird trans. Must have a turbo 350 trans. A 4spd would be straight bolt in. Build your own sub frame connectors. 1in square tube with flat plates on the ends. Tack weld down the back side of rocker/frame and flat plates to flat plate on car. You will see what I mean when ya climb under it! Good luck and have a Wheel Hoppy Easter....Keep em smokin.

Posted by: justabird

02/24/2007 06:35PM

Hey....SUBFRAME CONNECTORS at least. 4 point rollbar will finish whatcha need to stiffin it up! TRUST ME! A V8 will twist the body. You will be lookin at a rear end change as well. The 3;73 gear 1 tire spinner will not hold up to an 8. Justa givin ya a headsup! 5 stars for keepin Pontiac ol birds on the road!!! Check mine out if ya get a chance and drop a post on whatcha think...Keep em smokin dude...THEN let er drift!!!