Custom Lighting
Dont forget to RATE
Headlights
Tail Lights ( see page 3 for more pics)
My Plasma Glow led wheel well kit
How To Wire up the one piece headlights.
The red and white wires are the power and the blacks are the Grounds. You are going to need some electrical wire(around 14 gauge), electrical tape, wire stripers and some twist on wire connectors(wire nuts). Start by removing the old headlight assemblies one at a time so that way you dont confuse the low beams with the brights (dont touch the bulbs with your hands they will blow). Then take off your side markers. Also i would cover your bumper with some sort of cloth i scratched my bumper up a little while doing this. Next You will be wiring the led's and the halos to the side marker lights. Now cut and strip the 2 wires that go to the side marker light. Once done and depending on if you want the LED's on all the time or if you want to use them as blinkers, here is instructions to both.
Here is a comparison - left leds on all the time and right with the leds for blinkers
BLINKERS first, connect the red wires to the brown wire on your side marker and attach the white wires to the blue. then use your wire to extend the side market wire a little bit because it is hard to get the lights in with the stock shortness of the wires.
Like this
overall view with the wires extended
NOW Constantly on with lights
Connect the red and white wires both to the Brown and extend the wires like stated above. connect nothing but the extended wire to the blue.
Like this
and of course put wire nuts on it
Then for both processes you have to ground all black wires some where i found it easiest to ground them on the bolt that connects your fender to the body of the car.
Like this
Then the rest is just plug and play plug the lows into the projectors then put the highs in the high spot.(dont touch the bulbs)
ANY QUESTIONS FEEL FREE TO ASK!!
Page 1-Intro
Page 2-Interior
Page 3-Audio
Page 4-Exterior
Page 5-Night Pics With a Sunset
Page 6-Custom Lighting(you are here)
