
On this page are pics of the subwoofer cover that I made to replace the seat backs that were removed. Future plans are to remove the seat bottom and build an amp rack and move the amps & cap to the inside of the car. Blue LED lighting will be added between the cover & the sub enclosure. The 2 holes on the sides are for the upper strap of the 4 pt. harnesses that attach to where the fold down seat backs used to latch on to.
*********************************************************************************************************************
************************************* Here is the frame fitted in the car *************************************


****************** Here the fleece is stretched over the frame and coated with resin********************


**************************** Here it is covered with vinyl & installed it my ride *****************************


**************************** Here it is covered with vinyl & installed it my ride *****************************

I started fabricating the amp rack that will replace the rear seat,below are pics of the project so far.
*****************************************************************************************************************










Here are some shots of completed amp rack and cover project, not bad for the first attempt and fabricating with the fleece and resin. I must say that designing and building the framework was the most diffacult part of the project, getting it to fit properly and all.
*****************************************************************************************************************





