17-August-2009, new 28 spline axles arrived from Alloy USA. Still need to get bearings for the carrier, shims and a weekend to put the stuff together. 14-September-2009, Rear end rebuild complete. Precision Gear 3.73 ring and pinion with Eaton Posi carrier. The axles from Alloy USA were quite the challenge, they came with bearings, seals and wheel studs, everything you need, right, think again. The buttons for the C-clips were too thick and had to be machined down to even install them. The wheel studs weren't even the correct ones for the application, they were a bit small for the holes in the axle flange, and the wrong thread pitch - they stripped with any torque applied to tighten them, and one even twisted in the flange. A few trips to the machine shop and parts store and all bearings are pressed on and new ARP wheel studs installed.