If your not a member just E-Mail your comments or questions to me at flaymon1@aol.com
Check out this bad ass Ranger.---------------------------------yup it has four doors
2.5-litre Duratorq diesel engine.
clicky-clicky
Ranger XLT Crew Cab
Ranger Thunder
Ranger Thunder
Ranger Thunder
Sam's 2.8L Power Stroke turbo diesel
I have posted some basic info about my custom parts and mods
If I've left out some thing you need for your own Ranger project let me know and I'll try to post it.
These are photos of my custom ram air, I found the basic plains on
TRS and kind of ran with it.
Keep in mind this works on my truck because I have a 3" body lift and If your truck isn't lifted the pipe will not fit between the frame and the core support, I've not checked it out but you my be able to drill a hole threw the core support with a hole saw.
The ram air is made of parts from LOWES starting with a length of 3" SD 35 PVC pipe 4 PVC elbows and a gutter down spout.
Don't forget to put some kind of mesh or screen over the inlet to keep any unwanted road objects out like birds,rocks,bugs and snow if you live up north like i do.
I used some gutter guard mesh i found at LOWES its cheap and looks good.
06 Ranger XLT name plates.
I added tow Hooks on the front.
Custom painted gages.
After removing the gage cluster if your careful you can remove the clear plastic cover with a small flat screw driver a stiff blade or i used my pocket knife but not to cut to pry it apart SLOWLY so not to brake it.
Here are some of my painted interior Peace's for how to info check out TRS
GM rear view (map lights) don't tell those Chevy guys.
I made a custom hood scoop,
It's not finished but its a work in progress.
(Hood from downer truck)
_____________________________________________________________________________________________
This is not water proof water can run between the sides of the cover and the bed its only purpose other than for its great look is to keep the rain/snow off my tools and improve gas mileage.
If anyone makes one or has a Q. send me an E-Mail
(NOT WATER PROOF)
Here are some photos of my home made bed cover,
This project cost me 30$ at LOWES not including the rubber canvas, that was free.
1.Liqud nails(every joint)
2.(3) 2x3x10 "STRAIT" wood
3.(2) 1x1x10 "STRAIT" wood
4.(2) Gate latches
5. 4" deck screws(drill pilot holes or the wood WILL split
6.(4) 3/8x6Bolts and 8 nuts/washers
7. rubber canvas / vinyl
Just a tip measure the bed side to side and subtract1/4 from that, do the same long ways too if you don't the cover will fit to tight and the cover will not open and the tailgate will not close.
.>
My painted grillI wish I could take all the credit for it but I coped it from someone else.
4 Wheels for sale like new with all 20 lugs 15x7---------------------All 4 center caps as well
This ranger belongs to a friend of mine.
That's my girlfriend Jennifer.
Page 1 My 98 Ranger before and after.
Page 2 My parts truck and motor swap.
Here 3 My custom parts and mods.
Page 4 Photos of my 96 Ranger.
Page 5 Ranger history.
Page 6 Video library
Page 7 Design studio.
TRS tech forum.
Big bad Stang!!!
Ranger takes on SRT/10
04 Ranger EDGE
