Log In|Join Now
Remember me
Forgot Password?
Home > Ford > Mustang > 1984 > Tony's Ford Mustang
Message:
To:
tonysmustangs
Want to become a Fan?Login or Register
Member ID: tonysmustangs
Location: New Lexington, OH
Login to Message Login to Add Friend
1984 Ford Mustang
Bought: Jan, 0001
Sold: Jan, 0001
Login to rate
Login to Favorite
Forward to a Friend
Report Abuse
94-98 FORD MUSTANG CRYSTAL HEADLIGHTS+CORNER 95 96 97 $43.70
2003 03 FORD MUSTANG POWER SIDE MIRROR L NEW $38.25
87-93 FORD MUSTANG 1PC LED HEADLIGHTS 88 89 90 91 92 $105.08
SONAR 2005-2008 MUSTANG PROJECTOR HEADLIGHTS 2006 2007 $92.95
Metco 100mm Idler Pulley 03-04 Mustang SVT Cobra $35.00
Last updated: Aug 13, 2009
Hits: 19,734
Page 4 of 9
<<<123456789>>>
This is a aftermarket steering shaft made by BORGESON. It eliminates the factory rag joint. This is not one of those steel ones flaming river makes this one is made of billet aluminum and is 8lbs lighter than the stock one is. BBK caster camber adjusters. There made from polished billet aluminum and come with polyurathane strut bushing for better handling. Lakewood 90/10 drag struts to help with weight transfer. When I get my coil over spring this is what there going on. 8 quart road race oil pan. Thats right 8 quart oil pan for a 4cly. With oil filter it will take 9 quarts of oil to fill this little motor. Its got two kick outs. They did it this way to save on ground clearance. The smaller kickout is where my starter goes. And five trap doors. C line oil pans made this one. Its a real nice peice. It dont have a windage tray or crank scraper. I have one that bolts to the motor so the one in the pan is not needed.
This is my driveshaft safty loop. Its big because its made for the large aluminum driveshaft, and is shaped like the floor board. It makes it real easy to install. Holley fuel pressure gauge some anodised blue carb stud nuts and an aluminum air cleaner nut. 3 inch exhuast cut out.
Displaying entries 1-5 of 42
Login to post a comment
Posted by: 1ponybeast
08/13/2009 11:51PM
..yep, she's lethal..what's the numbers? I'd guess low 10's!?
Posted by: loudsho94
08/13/2009 10:05PM
wow you've done alot of work to that 2.3 lookin good man 5 starz
Posted by: JRhapsody
06/23/2009 12:14AM
Love the 2.3 pictures. Man about how much HP do you have, I'm doin the same thing accept for autocross and road racing. Some of those parts tyou got I've never seen before. Hey those headlights covers come in clear and help reduce drag.
Posted by: AintFukingScairt
06/19/2009 08:48AM
Are you using stock bottom end. If not what did you change to turn that fast? I would like to put some smake down on some imports around here.:)
Posted by: SVOMark
12/02/2008 12:07AM
Nice stang! It's cool to see a normally aspirated 2.3 putting down some power!
Show Older Comments
Post a comment
You must be logged in to post a comment
Recipient's:
Comments:
