Here are a few pics of the truck with the roof basket on and the rock sliders as well. You can see the custom grill is now missing as I had a bit of dive into a mud pit that was not so forgiving at jamboree last summer.CURRENT NEWSUPDATE: JANUARY 29/2009Ok, I really hope to be updating way more often in the next little while. Garage is pretty much built, took alot more time and energy than i had hoped, but once completed it is going to be a good little shop to work on my truck, cars, and motorcycles.I am pretty excited, as in the next couple weeks i am expecting a rather large shipment of parts! I will be adding a new page here to document my build, and hope to make quite a bit of use of my camera during the lengthy process I am about to embark on!I also now have purchased a miller welder, so alot of the plans I have drawn up and redesigned over and over again will hopefully become reality sooner than later. Now I just need my buddy to bring his plasma cutter over and get the truck up in the air on some blocks! UPDATE: FEBRUARY 17/2008I know it has been a long time since I have updated. There has been no off roading for me this winter as I snapped the passenger side cv shaft completely off of the back of the knuckle! So I have decided to wait to finish my next big project. I have been collecting alot of parts and am hoping to have everything ready to go late spring when I have my garage finished. I decided I wanted lockers and some gears and I am sick of 31's, so that is a bit of a clue! Also before I can get going on this round of mods, I have to get the rear disk conversion done on my car so I can drive it for a couple months! Also, I have been working on designing the new front and rear bumpers, I am hoping to have them done by late spring as well. I have finally Taken a few photos of my roof basket I had built back in the fall.