Vehicle Owner

Member ID: AERuffy

Location: Griffin, GA

Vehicle Info

2000 Chrysler 300M

Bragging Rights

  • 1/4 Mile15.9 sec @ -1 mph
  • 0-607.7sec
  • Top Speed139mph
  • HP252
  • Weight3650lbs

Major Upgrades

  • turbo
  • nitrous
  • bore increase
  • port and polish
  • supercharger
  • extrude honed
  • stroke increase
  • engine swap

Modifications

Performance Parts

  • K&N Intake 
  • Bosch Ignition 
  • TRD Brakes 

Interior

Exterior Styling

  • StreetGlow Lighting 
  • Custom Body Kit 
  • Kumho Tires 

Car Audio & Video

Ratings

    • Currently 3.3/5 Stars.
    • Currently 3.3/5 Stars.
    • Currently 3.2/5 Stars.
    • Currently 3.2/5 Stars.
    • Currently 3.5/5 Stars.

Login to rate

 

Last updated: Aug 27, 2007

Hits: 11,303

Ruffy’s Chrysler 300M

  • Currently 3.2545454545454 /5 Stars.
7 guestbook comments

AERuffy's 2000 Chrysler 300M Here you see some blue Festoon bulb LED's installed in the door. They add a cool effect. I might replace them with hyper white.
AERuffy's 2000 Chrysler 300M Rear door. The door has blue. The top bulbs are white leds.
AERuffy's 2000 Chrysler 300M Roof center console. I will take a better picture later. Going to replace them again with brighter LED's.
AERuffy's 2000 Chrysler 300M My headlights were in terrible condition, So I decided to polish them, Here you see the passenger side done. I Started with 800grit Wet sandpaper, Then went up to 1000 grit, then 1500 grit, 2000 grit, Finally 2500 grit. Then I polished and buffed it with some Meguiers Plastic-X Polishing compound.
AERuffy's 2000 Chrysler 300M Here you see a closeup of the Drivers Side after it's done. Looks good. I'll eventually get new ones. I'd like HID's. But for now I saved myself $300-400 easily.

AERuffy's 2000 Chrysler 300MHere you see a usefull mod. I had a power inverter that I used all the time for my laptop and other things. The only problem is It's noisy and a pain to carry around. So I decided to stealth it in the trunk and intergrate the jacks into the center console. Heres the jacks
AERuffy's 2000 Chrysler 300MHere you can see the back, I ended up using some hotglue around the jacks(not shown here) Next update I'll show the Modified power inverter and how it looks in the car

AERuffy's 2000 Chrysler 300M Sylvania Silverstar Bulbs for my Hi-beams, and Lo-beams. I'll be getting the Foglights if I can find them

Page 1 : General Information - Introduction
Page 2 : Wheels, Brakes, Tires, Suspension *Updated 9/10/06*
Page 3 : Audio System - Wiring, *Updated 6/20/06*
Page 4 : Audio System - Sound Deadening *Updated 7/6/06*
Page 5 : Audio System - Speakers / Subwoofers Installation *Updated 9/10/06*
Page 6 : Audio System - Video, CarPC, Navigation, Head Unit *In Planning*
Page 7 : Exterior *Updated 9/10/06*
Page 8 : Lighting & Electrical Mods *Updated 9/10/06*
Page 9 : Intake and Exhaust Modifications *Updated 9/12/06*

Guestbook

Displaying entries 1-5 of 7

fromLOWtoSHO  

Posted by: fromLOWtoSHO

01/24/2009 11:01PM

Sweet ride man.

firecatf7  

Posted by: firecatf7

12/02/2008 02:11PM

What size Festoon bulbs did you use on the doors? I have all 4 194 Wedge styles replaces inside, looking to do the 4 festoons (1 in each door) But there are MANY different Models, and unfortunatly I do not have any of the stock ones to judge. Thanks

donnyh18  

Posted by: donnyh18

09/12/2006 08:48AM

nice car, I like it. check out my car and let mw know what you think.

Barto1127  

Posted by: Barto1127

08/25/2006 09:56AM

Hey nice looking car keep it up!

kcarlos2000  

Posted by: kcarlos2000

08/21/2006 05:25AM

Had to stop by and check out your page, give you a little rating boost. Check out my page when you get a chance. BTW this is kcarlos2000 from dodgeintrepid.net

Show Older Comments

Post a comment

Bookmark this Ride

Vehicle Owner

Member ID: AERuffy

Location: Griffin, GA