Wiring Her Up - I Will not be using the streetwires fuse holder. I hate it. Engine bay being cleaned up as I go.
Had to get her up on rampstands to do this work. I routed the cable through some ductwork, into the wheel well and finally into the cabin.
Heres the wire running through the engine bay.
Ended up hiding the wire under the carpet. Had to pull up trim and carpet to get it where it's at.
Stingpro Digital ANL Fuse Holder. Looks decent and it's easier to swap out the fuse on it.
KnuKonceptz Distribution Fuse box, fuses and so on. Using it for the itme being because it was cheap.
Here's a closeup internal shot with fuses in it. It accepts two 0/1 Ga inputs, and can do a combonations of 8ga, 4ga and 0/1ga out.
Stinger 1/0Ga In, 2x 4ga Out, 3x 8Ga out. I'll be using this as a Ground distribution block.
Heres a shot of how things are being routed. Streetwires clamp is being used for factory wires too.
Here we go. Engine bay is starting to look Clean. Used some blue tubing to protect the cable. Yeah I know the blue Streetwires cable looked nice. But it was getting scuffed up to hell.
Products Used :
Streetwires 1/0 Amp Wiring Kit $99
Stingpro 1/0Ga ANL Digital Fuse Holder $20
Stinger HPM Distribution Block $20
KnuConcepts 3 Output Fused midi Distribution Block $20
EdZ 2ft Red 1/0Ga Wire $6 (Paid too much)
Summit Corrugated Blue Tubing Kit $13
Next Updates :
Knuconcepts Power Distribution block.
Wire cleanup.
Possibility of a Wiring board.
Page 1 : General Information - Introduction
Page 2 : Wheels, Brakes, Tires, Suspension *Updated 9/10/06*
Page 3 : Audio System - Wiring, *Updated 6/20/06*
Page 4 : Audio System - Sound Deadening *Updated 7/6/06*
Page 5 : Audio System - Speakers / Subwoofers Installation *Updated 9/10/06*
Page 6 : Audio System - Video, CarPC, Navigation, Head Unit *In Planning*
Page 7 : Exterior *Updated 9/10/06*
Page 8 : Lighting & Electrical Mods *Updated 9/10/06*
Page 9 : Intake and Exhaust Modifications *Updated 9/12/06*
