The next pics should give you an idea of the interior and how it will flow. The whole point is to keep the stock look...working around the obvious changes that were out of my control due to the nature of the project....you can't have your cake and eat it too ;O). I think that a very close stock look can be acheieved and look very appealing. The back seat will be functional...it will just end up being two bucket seats for skinny people :O). I will have to narrow the seat two inches on each side (roughly) and raise the center. The (outside) side pieces will have to be remade (altered) to fit...but will resemble the stock panels with arm rest, just changed enough to fit. The backing that the seat back attaches to will just have to be narrowed and fit back into place. The rear window shelf (package tray) will just have to be raised a fraction from the stock location...this is just as of now...when I actually get to it, it may even relocate to its original screw holes...we shall see, either way I'm getting back in there :O)! I will also have to trim each side out to fit around the wheel tubs, but the top will fit flush.

Page 1: Intro / Initial Pics, front cross member
Page 2: Hidden Cage / Back Half
Page 3: Trunk Tubes / 4-Link
Page 4: Front Suspension Mod / Rear Wheel Tubs / Shifter, DS Loops and Tunnel
Page 5: Interior
Page 6: Exhaust