Here are some of my mods.

SP Performance Diamond Slotted rotors painted red. I painted the calipers when I replaced the rotors.

I started painting some of the smaller pieces under the hood.

What the driver gets to see. New SRT-10 seats, I still have to change the headrests.

Intro Ram 5's 20x10's with Nitto 420S 305/50-20's. My stock rim and tires vs new ones.

Bedrug and tonneau liner match perfectly. I put LED lights under the bed rails.

Here are the old stock pedals and my new Ford Harley Davidson Edition F-150 pedals.

These are the front and rear sway bars which were powder coated red and my drop spindles were powder coated black. The spindles were part of the 2/4 lowering kit.

This is my Dynatech Headers and cats coated. This is my custom exhaust past the cats with Flowmaster Super 40. I have since built another middle section with an Original 40 and a manual cutout.

Here are the badges that didn't make it past day 2.

I removed the tow hooks and put in this custom lower grill. And here are the headlights comparing the stock ones vs. the new ones with clear corners.

This is a picture comparing full wheel well liners vs the stock ones and a picture of the liners installed.

The clips and fasteners for the liners bothered me after I put them on so I took them off and painted them. I painted all the fasteners and clips all around the truck similar to these.

New Taylor 8.2v Red Shorty Plug Wires

Inside of the cab I started adding some more silver. I also installed an SRT-10 push button start.

Intro Ram 5's Wheels, Nitto NT420S 305/50-20 and a Yorkie

2600 stall Edge torque converter and PML deep transmission pan.

My Dynojet Wideband Commander kit.

Next project is to remove everything that is blocking the view of the engine from the passenger side. I still need a new overflow bottle for the radiator and a new windshield washer resevoir. I'll also fabricate a custom intake to move the air filter into the shaker and then remove the shaker ducting and cold air box.

Here is a picture of a bracket I made to mount an FK-60 fan controller. And the frame for the Viper fan I built and painted black.

This is my new coolant overflow tank with brackets attached. The fan, controller and overflow tank are installed and wired up.

My new windshield washer resevoir. It is hidden under the front bumper in front of the passenger side wheel well.

 

Page 1: Intro
Page 2: Basic Overall Pictures
Page 3: Some Pictures of mods and Shaker mod
Page 4: Sound System
Page 5: Sound System Install
Page 6: What the truck looked like Stock
Page 7: Pictures with or of other cars
Page 8: List of modifications