Posted by: geilesAuto

07/29/2008 06:54AM

i love your ride, 5 stars for sure! come check out my ride

Posted by: jrames411

04/12/2006 08:55AM

It's the original bar, I just cleaned it off, wet sanded, spray painted with red dupli-color paint and a clear coat. You told me before that you knew a place to get a p-chip cheaper than $300, where can I find it?

Posted by: mkhalil

03/21/2006 11:32AM

Hi there, well you have along way to go man, first of all, TT mods are expensive, very expensive. I would start off with a divertor valve, surely not a blow off valve. If you dont know the difference then you should read tech articles about it. Forge's DV is one of the best, Hyperboost is great as well (www.stratmosphere.com). Then think about lowering, exhaust and probably chip. Working on the exterior, the rieger kit is a good choice, I have it on my ride. It was difficult to install though. Change the grill too. However, if your car is lowered and has the riger kit installed, you will not be able to drive it, or even jack it up without at least 19' wheels. It will be a tight fit but it works. Personally, I have been modding my ride for 3 years now. The experience is vey rewarding. You will have fun, the car is a timeless masterpiece. Rate my ride please and keep us updated. Good luck...with the car and the babe :)

Posted by: jrames411

03/11/2006 09:35AM

yeah, definitely let me know where you can get one for cheaper than 300.

Posted by: Motorheadbanger

03/10/2006 07:14AM

nice ride, for the audi TT engine is better to install a diverter valve instead of a blow off valve... otherwise you might screw up the engine... go and check thettshop.com