Log In|Join Now
Remember me
Forgot Password?
Home > Ford > Mustang > 1967 > Mark's Ford Mustang
Message:
To:
Red5oh
Want to become a Fan?Login or Register
Member ID: Red5oh
Location: Keller, TX
Login to Message Login to Add Friend
1967 Ford Mustang
Bought: Jan, 0001
Sold: Jan, 0001
Login to rate
Login to Favorite
Forward to a Friend
Report Abuse
GT 390 Fastback $2,800.00
1988 FORD MUSTANG GT CONVERTIBLE NEW PAINT EXTRAS CLEAN $5,775.00
2001 Mustang Gt convertable $7,299.99
1968 FORD MUSTANG STREET LEGAL TRANS AM CLONE $12,600.00
1969 Ford Mustang R-code (428cj) Fastback $18,600.00
Last updated: Aug 09, 2009
Hits: 22,436
Page 12 of 19
<<<1101112131415161718>>>
This is the trunk painted. This will allow me to start putting the wiring for the tail lights, battery, fuel shutoff, etc back in and get it running. I know it runs well, but it would be nice to be able to move it about with the engine running again.
The paint was ok... there are some dust spots in it, but hey... its only a trunk and it will more than likely get carpeted anyway... I just like it to look as good as possible.
Displaying entries 1-5 of 14
Login to post a comment
Posted by: michaelnsusan
09/16/2009 03:55PM
FANTASTIC car, clean and classic. both me and my wife like it ! Looks like you take good care of it, Great job !! My car is almost just like it but I finished back in 97, my body parts are from miaer racing and I also did the side scoops. your right about the end caps being hard but I sanded a little at a time and it turned out nice, are you going to put the hood trim on to complete the front? I had to bend mine to form a tight fit and then I fiberglassed it on from under the hood, plus I added the front valance with the radiator opening on it. Check it out and see.
Posted by: TARA-fied
01/04/2009 09:45PM
Awesome work. great documentation too. I have done a lot of the same to mine. I hope all is well with you. Good luck.
Posted by: zak7711
06/14/2008 12:54AM
Great job! I'm sure you've inspired many people like myself to start restoring their rusty old ponies. Thanks and all the best!
Posted by: kerrinjeff
06/19/2007 01:15AM
You have a great project going there. I can't wait to see it when it's done! You are definitely doing the job right...
Posted by: MustangChuck
05/21/2007 11:07AM
I have two questions about your 8.8" rear end install. Where did you buy the spring perches and why did you need to replace the axles? Thanks, MustangChuck
Show Older Comments
Post a comment
You must be logged in to post a comment
Recipient's:
Comments:
