Vehicle Owner

Member ID: Red5oh

Location: Keller, TX

Vehicle Info

1967 Ford Mustang

Bragging Rights

  • 1/4 Mile0 sec @ -1 mph
  • 0-600sec
  • Top Speed-1mph
  • HP225
  • Weight-1lbs

Major Upgrades

  • turbo
  • nitrous
  • bore increase
  • port and polish
  • supercharger
  • extrude honed
  • stroke increase
  • engine swap

Ratings

    • Currently 3.1/5 Stars.
    • Currently 3.3/5 Stars.
    • Currently 3.4/5 Stars.

Login to rate

 

Parts On eBay

Last updated: Aug 09, 2009

Hits: 22,422

Mark’s Ford Mustang

  • Currently 3.1 /5 Stars.
14 guestbook comments

Red5oh's 1967 Ford Mustang


My father, George - age 28, just out of the Navy.

This is a page to briefly give tribute to my father.

He is the reason I can work on cars like I do and was responsible for beginning to teach me to work on engines/cars/equipment from his small engine repair business he had for over 25 years.

Prior to starting his own business, he was a machinist for 10+ years, so it gave him a wealth of knowledge to pass on to his sons.

I am here to say, I feel he did a great job on passing on that information to me and my brother, and it is my honor to say I hope I have learned a portion of what this great man has forgotten in his long and prosperous life.

He was a great man, husband, father, grandfather and teacher and I will miss you more than words can describe. May you look down on me from time to time and feel proud of the job you did with me. I also hope to bring continued pride to the family you left behind by being a good man, father and son.

Thank you for a very good life, and I love you so much.

Red5oh's 1967 Ford Mustang


7/11/32 to 2/10/06

Guestbook

Displaying entries 1-5 of 14

michaelnsusan  

Posted by: michaelnsusan

09/16/2009 03:55PM

FANTASTIC car, clean and classic. both me and my wife like it ! Looks like you take good care of it, Great job !! My car is almost just like it but I finished back in 97, my body parts are from miaer racing and I also did the side scoops. your right about the end caps being hard but I sanded a little at a time and it turned out nice, are you going to put the hood trim on to complete the front? I had to bend mine to form a tight fit and then I fiberglassed it on from under the hood, plus I added the front valance with the radiator opening on it. Check it out and see.

TARA-fied  

Posted by: TARA-fied

01/04/2009 09:45PM

Awesome work. great documentation too. I have done a lot of the same to mine. I hope all is well with you. Good luck.

zak7711  

Posted by: zak7711

06/14/2008 12:54AM

Great job! I'm sure you've inspired many people like myself to start restoring their rusty old ponies. Thanks and all the best!

kerrinjeff  

Posted by: kerrinjeff

06/19/2007 01:15AM

You have a great project going there. I can't wait to see it when it's done! You are definitely doing the job right...

MustangChuck  

Posted by: MustangChuck

05/21/2007 11:07AM

I have two questions about your 8.8" rear end install. Where did you buy the spring perches and why did you need to replace the axles? Thanks, MustangChuck

Show Older Comments

Post a comment

Bookmark this Ride

Vehicle Owner

Member ID: Red5oh

Location: Keller, TX