Here is my intercooler setup half complete.
i have cut and welded the old inducer manifold to retain the support mount, die ground and polished the inside out so it is smooth flowing everywhere.
cut the throttle body off the original side and welded it on the other side and then machined everything flat again (its good when you work at an engineering workshop) the throttle body is then turned upside down, because there was no room for the intercooler piping to go to the throttle body and just because it will look neater. all the throttle linkage is retained as standard, just upside down.
i have lengthened the wires for the MAF, IAC, ATS and the TPS connections.
the car is ready to go to plazmaman racing for the 2 1/2'' piping and cooler to be fitted.
Here are the pics
