Close

Forgot password?

Log In | Join Now

Vehicle Owner

Member ID: TireFryer86

Location: Deltona, Florida

Vehicle Info

1986 Chevrolet Camaro

Bragging Rights

  • 1/4 Mile10.8 sec @ 126.1 mph
  • 0-6099 sec
  • Top Speed130 mph
  • HP467
  • Weight3680 lbs

Major Upgrades

  • engine swap
  • nitrous
  • bore-increase
  • extrude-honed
  • stroke-increase
  • port and polish

Ratings

    • Currently 4/5 Stars.
    • Currently 3.5/5 Stars.
    • Currently 3.5/5 Stars.
    • Currently 3.5/5 Stars.
    • Currently 3.5/5 Stars.
    • Currently 3.5/5 Stars.

Login to rate

 

Poll

Question: front suspension upgrade?

Last updated: Nov 16, 2008

Hits: 13,408

Nick’s Chevrolet Camaro:
“"10 Sec Z"”

  • Currently 4/5 Stars.
74 guestbook comments

This is my new custom dual 2 1/2 inch exhaust over the axle with an H pipe and dynomax welded ultraflows.

A pic from the back with it up on the lift.
TireFryer86's 1986 Chevrolet Camaro Deltona, FL Customized with Custom Sub Enclosure, Cadence Tweeters, Cadence Speakers, Cadence Subwoofers, Cadence Amplifier, Comp Cam Engine Comps., Custom Exhaust, Hedman Header, Edelbrock Intake, MSD Ignition, Custom Wheels, B&M Shift Knob, Mickey Thompson Tires, Custom Seats, Grant Steering Wheel, Auto Meter Engine Electronics, Custom Shocks, Custom Transmission, Monster Cable Wiring, Auto Meter Gauges - 71

under from the left side

TireFryer86's 1986 Chevrolet Camaro Deltona, FL Customized with Custom Sub Enclosure, Cadence Tweeters, Cadence Speakers, Cadence Subwoofers, Cadence Amplifier, Comp Cam Engine Comps., Custom Exhaust, Hedman Header, Edelbrock Intake, MSD Ignition, Custom Wheels, B&M Shift Knob, Mickey Thompson Tires, Custom Seats, Grant Steering Wheel, Auto Meter Engine Electronics, Custom Shocks, Custom Transmission, Monster Cable Wiring, Auto Meter Gauges - 72

under the rearend of the car. showing the H pipe
TireFryer86's 1986 Chevrolet Camaro Deltona, FL Customized with Custom Sub Enclosure, Cadence Tweeters, Cadence Speakers, Cadence Subwoofers, Cadence Amplifier, Comp Cam Engine Comps., Custom Exhaust, Hedman Header, Edelbrock Intake, MSD Ignition, Custom Wheels, B&M Shift Knob, Mickey Thompson Tires, Custom Seats, Grant Steering Wheel, Auto Meter Engine Electronics, Custom Shocks, Custom Transmission, Monster Cable Wiring, Auto Meter Gauges - 73

the midered joints going from the Hedman LT's under the crossmember.
TireFryer86's 1986 Chevrolet Camaro Deltona, FL Customized with Custom Sub Enclosure, Cadence Tweeters, Cadence Speakers, Cadence Subwoofers, Cadence Amplifier, Comp Cam Engine Comps., Custom Exhaust, Hedman Header, Edelbrock Intake, MSD Ignition, Custom Wheels, B&M Shift Knob, Mickey Thompson Tires, Custom Seats, Grant Steering Wheel, Auto Meter Engine Electronics, Custom Shocks, Custom Transmission, Monster Cable Wiring, Auto Meter Gauges - 74

the hanger on the mufflers.

TireFryer86's 1986 Chevrolet Camaro Deltona, FL Customized with Custom Sub Enclosure, Cadence Tweeters, Cadence Speakers, Cadence Subwoofers, Cadence Amplifier, Comp Cam Engine Comps., Custom Exhaust, Hedman Header, Edelbrock Intake, MSD Ignition, Custom Wheels, B&M Shift Knob, Mickey Thompson Tires, Custom Seats, Grant Steering Wheel, Auto Meter Engine Electronics, Custom Shocks, Custom Transmission, Monster Cable Wiring, Auto Meter Gauges - 77

With this exhaust I have around $170 into the mufflers. 3 sticks of pipe 8' each $75. and the hangers about $20. I also used bits and pieces off of my single exhaust 90's and stuff like that. so for less than $300 you can have a dual exhaust kit out the back that is quiet inside the car but echos the neighborhoods outside. also the hedman long tubes ceramic coated $385.there was barely any mods done to the floor other than the back where the subwoofer box sits. and by looking at it you cannot tell it was touched. The performance gains where huge at the track i gained over 3 MPH and 2 tenths over a 3 inch single kit with a y dump. it is around a 6 MPH over the entire single exhaust. i figure around 40-50 horse increase over the old kit. not to mention it sounds awesome. ground clearence isnt really an issue by me, i only scrape on the big speed bumps. I have about 4 inchs at the lowest point.
sound clip.

Bookmark this Ride

Vehicle Owner

Member ID: TireFryer86

Location: Deltona, Florida