Here is the lift I am currently running: PRG uca's and Radflo extended length coilovers
Some closeup pics of uca and Radflo's.
My custom built Alcan leaf springs.
Painted grill:
Fitting the Procomp 7089's required a little fender trimming due to the offset of -12 and the increased wheel width. A fairly easy job with a Dremel.
BEFORE:
AFTER:
Wiring the roof lights required drilling a hole in the existing rack and then drilling a hole in the roof (underneath the existing leg). From there you can easily run the wiring through the headliner and down the door molding to the dash. I wire loomed and electrical taped all of the outside wiring to waterproof it. Where the wiring entered the leg and the roof I placed a grommet in the hole and silicone sealed them up.
My AT jerry can holders (Wedco gas - Sceptre water)
My dual band 'ham' radio installation:
Under the driver's seat
Some pics after adding lift, 33" BF Goodrich ATs and sliders.
A few closeups of the Shrockworks sliders:
Here are a few pics of my bed-mounted Hi-lift jack.
