This took some pretty big BALLS! But the funs just starting :) This is a rough cut now I need to do the final trimming and alot of welding.
Little bit of MockUp Action.
Tacked into place. Now for alot of welding and grinding :)Looks so clean with the firewall all smooth and shaved. The Power brake booster and master cylinder now mount under the dash along with the Clutch master cylinder to help with that clean smooth look. Only thing that comes through the firewall is the steering column and engine wire harness, Although that hides above the bell housing on the tranny. :)
Looks so funny yet shittaaayyy :)
_______________________________________________________________
Heres where I cut the Whole floor out and back wall. I will be building a totaly smooth floor with a sweet tranny tunnel and smooth back wall along with the full roll cage
Here is where the transmission tunnel starts to be designed.
Test Fit engine inplace
_______________________________________________________________
Heres the cage in the works. Alot more left to be done.
Test fitting the Seats
Soon Enough :)
________________________________________________________________
Heres the Parallel 4-bar rear suspension setup with QA1 Adjustable coilovers and the wishbone track locator. Just waiting on the rearend housing to get here.
Fuel Cell Inplace
Here is the 9 inch rearend im waiting on now.
Aeromotive A1000 Billet Fuel Pump Mounting Plate.
ANTI ROLL SWAY BAR SETUP