Page 1: Car pictures / System Layout
Page 2: Installing wires
Page 3: Installing Illusion ND8's in doors
Page 4: Installing Morel MDT29's in kick panels
Page 5: Installing ADS 312rs.2 subs in trunk
Page 6: Converting dash to blue lights
Page 7: Converting Alpine HU to blue lights
Page 8: Misc install pics
Page 9: Future Upgrades
Page 10: Building passive crossovers

All power wire and accessories are Scosche EFX platinum series. As shown in the first picture, 0 gauge blue EFX wire is used for the positive connection from the battery to the trunk, going down the left hand side of the car through the main fuse under the hood. The negative terminal has two 0 gauge connections: one to the chassis, and one to the engine block.

Here the blue power wire can be seen running down the left hand side of the car:

All signal wires are Canare Starquad. RCA cables are made by me using Canare Starquad microphone cable with Scosche EFX platinum ends. At the HU, you'll notice a small blue wire extending out from underneath the white heat shrink tubing. The blue wires are ground wires, which are only on one end. The Canare wire has a metal braided shield around the entire length of the wire for noise protection. Additionally, the way the wire is twisted (Starquad), rejects noise. Each channel off the HU is run on its own seperate wire. The speaker wire is Canare Starquad speaker wire. For those that wish to check them out, their website is www.canare.com.

This picture shows the RCA wires about to be run from the trunk area:

Here are the RCAs run into the dash area:

In this picture the RCAs have been zip tied into place under the dash. Also shown are the drain wires connected to chassis ground. All left wires are on one, all right on another:

And here are the RCAs connected to the HU:

More pictures of the trunk connections and the speaker wire will be up shortly.