CarDomain Network: CarDomain StreetFire.net Autoholics

Vehicle Owner

Member ID: 626DXGT

Location: Plano, TX

Vehicle Info

1991 Mazda 626
View the Ride

Bought: May, 2005


Bragging Rights

  • 1/4 Mile0 sec @ -1 mph
  • 0-600sec
  • Top Speed-1mph
  • HP180
  • Weight-1lbs

Owner's other Rides
 

Updated on May 06, 2012

Hits: 35,256

626DXGT’s Mazda 626
“Sleeper626”

    • Currently 3.4/5 Stars.
     
    • Currently 3.4/5 Stars.
     
    • Currently 3.5/5 Stars.
     

this my page about my 1991 Mazda 626 DX. i got this car for 500$. it was in bad shape. it just needed some TLC.

626DXGT's 1991 Mazda 626

626DXGT's 1991 Mazda 626


626DXGT's 1991 Mazda 626
i had to replace some valve seals and a leaking rad. assembly. the intake boot was repaired and tires were replaced. i came apon a 1988 PGT for 200$ and couldnt pass it up. the motor was in need of rebuilding and the body was in bad shape. but the suspension and trans was useful.

626DXGT's 1991 Mazda 626

626DXGT's 1991 Mazda 626


i started the swap with the rear disc brakes from the drum brakes that came with the DX trim level.

626DXGT's 1991 Mazda 626

626DXGT's 1991 Mazda 626


626DXGT's 1991 Mazda 626

626DXGT's 1991 Mazda 626

i swapped the swaybars into my car. the PGt had the biggest rear sway bar of all the GD body style here in the states.
626DXGT's 1991 Mazda 626

626DXGT's 1991 Mazda 626


626DXGT's 1991 Mazda 626

Guestbook


Displaying entries 1-6 of 41

I_Drive_TOYOTA  

Posted by: I_Drive_TOYOTA

Just checked out all 13 pages, you've done a great job. Sweet ride. I've got an 89 PGT and I was looking for some good ideas. You have great attention to detail.

AndyVegan  

Posted by: AndyVegan

did you need spacers to use those mazda 3/6 wheels?

Spawn1981  

Posted by: Spawn1981

Hi there! really nice car and cool project! i'm looking for two parts for my GD, the digital speedo and the moving vent in the middle console! is it possible to find something in the USA?

ImportRacer93  

Posted by: ImportRacer93

Dude i can get you a digital dash if you still need it. Theres one chilling in the junkyard a block away

ImportRacer93  

Posted by: ImportRacer93

Sic GDs man. Is taht a AWR strut bar? Im currently working on swapping the motor tranny and rear end onto my 626. Right now the mods it has are Intrax suspension CAI, and custom exhaust with a civic short throw. In the next few days i hope to have my fuel cell in soon. Maybe on day ill get my mazda lookin as good as yours.

Blusube  

Posted by: Blusube

finally got my low springs in my car almost done

Show Older Comments

Vehicle Owner

Member ID: 626DXGT

Location: Plano, TX

 
FEEDBACK