Exterior and Installation Notes

Well I haven't Updated the page in a while so I thought that I would add some new pictures of the changes recently.  I've moved to the mountains and as such we like to hit the back trails sometimes.  The truck was recently upgraded with Cooper Discoverer STT mud terains.  Along with the new tires I added slotted and cross drilled rotors and new metallic pads as had some problems with the origional rotors.  Below is a description of the Audio install, followed by stock pictures of the truck and then pictures of the upgrades.

Since I plan on keeping the truck after school at least as a third vehicle I decided to step up the install a little bit from my previous versions. Most of the equipment will be the same, except the addition of a new SoundStream Amp and a set of component speakers. I also changed out the Subs I was using in my old Blazer, 2 12" Visonik DV6 Subs, for 2 new 10" Visonik competition series subs. While I loved the old Subs, I would not have been able to keep them without cutting through the bed and installing the subs in the truck box (Which the Wifey definetly wouldn't let me do) :0(

Enough of my Blabbing! On to the important pictures of the ride alteration.

Below is a Picture of the truck right after my wife and I purchased it:

Full view of the truck with the tonneau cover (I know these are horrible shots, I'll take some more when I have time):

Picture of the truck when it was stock out in the wilderness.

Full shots of the new Cooper Discoverer STT tires:

Shots of the new rotors in the front and rear:

Full side view of the truck:

Equipment to be installed:
Head Unit:
Pioneer DEH-P7400MP.

Subs:
Two Visonik V10DV6 10" subs.

Back Fill:
PPI 52.1 5 1/4" Carbon Fiber Coaxs.

Front Fill:
MA Audio Synergy SY66C2

Amp:
Cadence A7-HC. Monoblock sub amp, puts out 1200 watts at one ohm.
Soundstream EGA 2220. 2x110 watts for the comps.

Interconnects:
2 sets, 1 16.4' Stinger Dream series and 1 19.2' Stinger Dream series

Power wire:
Stinger 4 Gauge HPM Series clear cover purple for the power and ground wire.
The remote wire is Stinger 16g Purple.
Stinger 12 gauge pro series speaker wire.

Fuses:
I have two fuse holders in my setup. 6" from the battery the main in-line fuse, SFH1MDPT, will have a 120 amp fuse in it. In the rear, the power will run to a AF2MDPT 0-4/4 gauge fused distro with an 80 amp fuse for the A7HC and a 40 amp fuse for the Soundstream. Each amp will get 4 gauge in and 4 gauge to ground.

Sound damping
McMaster Hi-Temp Mastic

Page 1: Exterior Pictures and System Plans.
Page 2: Pictures of Phase I of the install.
Page 3: Pictures of Equipment After Phase 1.
Page 4: Pictures of Phase II install.