this is my new niki i got today! it has cromodora mag wheels and it has a momo sports wheel. cd player split spekers, all the tin ware on the motor has been powder coated

the motor has only been in a short time and has not had the rear bumper put back on yet. it has a heavy duty clutch

this is the side of the car, you mite be abell to see the dint in the driver side door.and the cromodora wheels

this is a picture of the one that i was going to put on the road and the one that is on the road now. this one with the black bumpers had good tyers and reg so i got a RWC for this one and now can drive this one

this is a pictue of my niki that i have just put fiat126 badges on it today (as they where sold over sea's with) but this 1966 cadillac parked in front of it

this is a frends cadillac that he has just got so we took some pictures at the lake here in bendigo, at the rowing club

this is the little motor, it is in the back and is air cooled, all the tin on it has been powder coated satin black

the wheels have been powder coated as well, they are 13x5in fiat 124 wheels. i have the crome caps for them but i dont like them as they cover up the nuts as well. i will try and get small one's just for the midle

here is a picture of my new alloy abarth sump and it holds 1/2 a litre more oil than the standed one, so this will help to keep it cooler and all the fins will help as well. i have had a oil temp sender taped in to the side as well so i can have a idear of the temp of the motor. i have all so got a new air filter that is a oil/fome one that can be cleaned and reused. a friend works in a motor bike shop and we looked threw all the stock to find one that will fit and this is the one that will fit. it is a yamaha yfm250x part number 4xe e4450uf and is made in the USA. he tells me it is for a 4 wheel motor bike. it is only 1cm to high to be perfect and as it has just wire mesh in side i will just cut 1 cm off it or squash it a little. the fome will be ok as it will seal very well. this filter is only open one one end witch is good

i fitted the air filter today! i had to take the fome off and then cut the mesh in harf, as it would not sqush. i cut some from the midle and then laced it together with copper wire! i went threw each of the holes in the mesh were they are put back together. i then put the 2 bits of fome back on and it is as good as new now

this is the iside of the sump. the temp sender gos in a little more as it was not done up in the pic

this is the sump on the car. as you can see it is a little lower to the ground now, and i only put it on so the temp sender is not hooked up yet

i have painted the abarth word on the sump now