Well we will start here.
The wiring for the passive crossovers has been run.These wires are for the doors and the kickpanels.
Interior panlels are in.
This is the rear chamber for the sub enclosure,I had some miscalculation issues,so after i had cut it down to size...........I had to add to it again..
The square notches are for clearence around the sheet metal which houses the trunk hinges.the other notch is for more clearence,where the wires pass from the trunk to the cabin...
in the car. this section is 1.5"thick on all sides fiberglassed all the way around on the inside,with 2 2x4 braces....Its solid ...and heavy..
Painted peices going in..
Memphis hangin out
This wonderful little paint gun had a glass bottle,which was dropped ......and broken,,,,so I had to improvise...
Interior panels were sanded with 100 grit,then covered with high build primer,sanded smooth,and sprayed green.
a few shots of the back side...
PAGE 13.........I begin work on the center console..