2/21/2003

Paintless Dent Removal (PDR)

Had Mauro DeLuna at Start to Finish PDR in San Antonio go over the entire car. There were 15 dings, 1 crease and 1 high spot that were addressed. Also had a rock chip in the windshield that was worked on.

Most of the dings were too small to photograph. Below are some of the larger examples.

Small raised area on front passenger door. Very difficult to see, but you may notice the slight bend in the reflection along the body line.

After.

Large dent in trim piece that also dented metal.

During the process.

After. Trim piece was replaced at a later date. The metal was straightened, but there was no way to make the trim look straight.

Medium sized crease in fender lip.

A slightly different angle of the crease.

After - There is still a small dent where the crease used to be. Mauro could not work it out any further without making it look worse than it was.

Two very small dings side by side on drivers door. These are hard to see - look for a bend in the reflection of the light.

After.

Rock chip in windshield. It was covered with tape to prevent water from entering before being repaired.

Repair in progress.

After. Can't see it? That's the idea.