(4-4-02)
Today I had some spare time so I decided I would run the ground wire.
We need to find the best ground source for our wire. This is normally the chassis. At first I thought I was going to have to drill a hole in the floor of the trunk but I looked around and it paid off. There was already a grommet leading to the outside of the trunk. I will use this to run my wire.
Wrap some tape around the 4ga wire to a leader wire so we can pull it through with ease.
After the wire is through put a silicone sealer around the wire at the grommet to prevent water or dirt from getting into the car.
Now to drill a pilot hole where we will bolt the connector to the chassis.
Let's go ahead and prep the surface now. I use a coarse sandpaper. If you wear rings make sure to take them off or you will end up sanding them also.
A nice clean surface.
We will now bolt the connector to the chassis.
And for rust protection we need to coat the bare metal. I use a rust preventive paint.
End.
Table Of Contents
PG 2................Radio Installation.
PG 3-7.............Dynamat Installation.
PG 8................Running the ground wire.
Pg 9-10............Running the speaker wire for the front stage.
PG 11-13.........Installing Sound Killer on the front doors.
PG 14-15.........Installing 6" components in the front doors.
PG 16..............System Diagram.
PG 17..............Systems and cars of yesteryear.
PG 18..............For Sale.
PG 19..............My New Toy.
This site was created to show my installation from start to finish and for that purpose only. This is not a training course or tutorial. In no way will I be liable if property damage occurs resulting in the use of this information.
.
.
