Alrighty to I got my Reverse Glow Gauges. Installed, Wired in, and Poped back in place. Heres what happend. Enjoy.

This is the Reverse Glow Gauge Kit still in the bubble wrap Right when it came in.

Here is the Whole Kit unwrapped and Layed out.

The back of the white face. It's set up with its own lighting system.

First off everything had to come out of the Dash board. The light switch was a bitch to take off. OMG. it took me like 20 Min to get that little thing off. It was a pain. Then the 4 screws that hold the Cluster in place came off. The instrument panel came out Easily after I figured out I had to unplugg the two big plugs in the back.

Heres the instrument cluster pulled out of the dash. It looked so much smaller once it was out.

The Instrument Cluster again but this time without the cover glass on it.

The explosed cluster, on my desk where i was working on it, with the Cover on top ready to put on. This was the Hardest part of the whole set up. In order to install the White Face. It was needed to remove the needles of the meters. I didn't wana do that. To much of a pussy was affraid id break them. I had to slide them over the needles into place. Which was horrible. But in the end I was able to slide the facing over the needles and into place. MUA HA HA HA.

Here is the White facing in place with the wiring and the Cover next to it. I also cleaned out the cover glass since it was out anyways.

THE FINAL PRODUCT. I LOVE IT.

.