CUSTOM RAV4 HYPERGROUND WIRE BUILD & INSTALL
This project was fairly easy with 4gauge speaker cable (I used SCOSHE EFX2) and some gold plated terminal co... Show morennectors.
All that you need to do is measure exactly how long each ground wire is going to be from point A to point B:
You need to have heavy duty wire cutters to cut the 4 gauge thick wire:
Cut away the extra silicone shield so that the terminal end can slip onto the wire and crimp tight. I used a small sledge hammer to do the trick:
Put some heat shrink tubing to cover the exposed wire and terminal ends and you have a completed custom ground wire:
Here are just a few shots of the many completed ground wires on my 1998 RAV4. If you have any questions or would like a set of DIY instructions, I have some PDF files of the whole process; just give me an e-mail message: Show Less
H&R 30MM WHEEL SPACERS,BREMBO CROSS DRILLED ROTORS, NISSAN SKYLINE RIMS
Here are some H&R 30mm wheel spacers. They were needed to flush the wheel/ti... Show moreres towards the fender flares. I would recommend the H&R's because they are designed to be hubcentric for your specific vehicle.
The generic ones as pictured under the H&R spacers caused vibration in the steering wheel at high speeds.
As for the BREMBO cross drilled rotors and HAWK sport pads, they are excellent; not a bad thing to say about this awesome combination of stopping power.
I replaced the factory alloys with some 16" factory Nissan Skyline rims. I sourced them from Japan. The dimensions and offset of the Skyline rims are very similar to that of the RAVs. The only thing needed for a good fit is some hubcentric rings. Here are some pictures of the type of car it came from and the rims on my RAV. Show Less